VICTRON MULTIPLUS 24/5000/120-100 INVERTER CHARGER
The new style MultiPlus is set to replace the earlier MultiPlus Compact range. It is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology and a high-speed AC transfer switch in a single compact enclosure. In the event of a grid failure, or when shore or generator power is disconnected, the inverter within the Multi is automatically activated and takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.
Output Current Rating (Amps) 120.0 Amps
Peak Power 10.000W
Output Voltage and Frequency 230 Vac ± 2% / 50 Hz ± 0.1%
Output Power 4000W (continuous output power at 25°C) | 4000W (continuous output power at 40°C) | 3700W (continuous output power at 65°C)
Input Voltage 19-33V
Operating Temperature Range -40 to +65°C
AC Input 187-265VAC | 45-65Hz | 1
Inverter Output Continuous Watts 4000W (continuous output power at 25°C)
Charge voltage 'absorption' 28.8V
Charge Voltage Float - Wet (25 degrees)** 27.6V
Charge voltage 'storage' 26.4V
Inverter Output Nominal Efficiency 94% (maximum)
No load power consumption 30W | 10W in search mode
Product Dimensions (mm) LxWxH 328 x 240 x 444
Net Weight (kg) 30.0 Kg
The full bridge plus toroidal transformer topology has proven its reliability over many years. The inverter is short circuit proof and protected against overheating, whether due to overload or high ambient temperature.
PowerControl - Dealing with limited generator, shore side or grid power
With the Multi Control Panel a maximum generator or shore current can be set. The MultiPlus will then take account of other AC loads and use whatever is extra for charging, thus preventing the generator or shore supply from being overloaded.
PowerAssist - Boosting the capacity of shore or generator power
Where peak power is so often required only for a limited period, the MultiPlus will make sure that insufficient shore or generator power is immediately compensated for by power from the battery. When the load reduces, the spare power is used to recharge the battery.
High start-up power
Needed to start high inrush loads such as power converters for LED lamps, halogen lamps or electric tools.
When Search Mode is ‘on’, the power consumption of the inverter in no-load operation is decreased by approx. 70%. In this mode the Multi, when operating in inverter mode, is switched off in case of no load or very low load, and switches on every two seconds for a short period. If the output current exceeds a set level, the inverter will continue to operate. If not, the inverter will shut down again.
By default, the programmable relay is set as an alarm relay, i.e. the relay will de-energise in the event of an alarm or a pre-alarm (inverter almost too hot, ripple on the input almost too high, battery voltage almost too low).